By default, the Project panel is situated on the left side of the work area and looks as follows:


    Fig. 2.10.a. Project panel for 3D project type                        Fig. 2.10.b. Project panel for Flip project type

Numbers in Fig. 2.10.a and 2.10.b label the following properties:

    1. Select the project type: 3D or flip;
    2. Select the lenticular type and open the lenticular manager window ("..." button);
    3. Change the overall 3D effect of the project;
    4. Set the background image;
    5. Select photo1;
    6. Select photo 1 for the Flip project;
    7. Select photo 2 for the Flip project.